Create your first repository, then add and commit files

Posted by admin at June 8, 2020

At the command line, first verify that you have Git installed:

To install git check out the http://gradevision.in/github-installation/
On all operating systems:

git --version

On UNIX-like operating systems:

which git

If nothing is returned, or the command is not recognized, you may have to install Git on your system by downloading and running the installer.
After installing Git, configure your username and email address. Do this before making a commit.
Once Git is installed, navigate to the directory you want to place under version control and create an empty Git repository:

git init

This creates a hidden folder, .git, which contains the plumbing needed for Git to work.
Next, check what files Git will add to your new repository; this step is worth special care:

git status


Review the resulting list of files; you can tell Git which of the files to place into version control (avoid adding files
with confidential information such as passwords, or files that just clutter the repo):

git add < … >

If all files in the list should be shared with everyone who has access to the repository, a single command will add everything in your current directory and its subdirectories:

git add .

This will “stage” all files to be added to version control, preparing them to be committed in your first commit.
For files that you want never under version control, create and populate a file named .gitignore before running the add command.
Commit all the files that have been added, along with a commit message:

git commit -m "Initial commit"


This creates a new commit with the given message. A commit is like a save or snapshot of your entire project.

You can now push, or upload, it to a remote repository, and later you can jump back to it if necessary.
If you omit the -m parameter, your default editor will open and you can edit and save the commit message there.

Adding a remote


To add a new remote, use the git remote add command on the terminal, in the directory your repository is stored at.
The git remote add command takes two arguments:

  1. A remote name, for example, origin
  2. A remote URL, for example, https:///user/repo.git
    git remote add origin https:///owner/repository.git
    NOTE: Before adding the remote you have to create the required repository in your git service, You’ll be able to
    push/pull commits after adding your remote.

Comments

Write a Reply or Comment

Your email address will not be published. Required fields are marked *